Glue and screw the pieces together, ensuring that the finished frame is square. Glue front frame together Once the middle, double plank has dried, it is time to connect the rest of the front together. Not that when looking at this piece from the front, it should look like one solid piece - the grooves should be in the back, not the front. The result should be a double width piece that has one side taller than the other. To make this joint use either dowel joints or biscuits. Finally, take the middle-right and taller middle-left planks and glue them together, side by side. all the way across the wood, rather than just 1 1/2' in) in order to slot into the middle groove cut out of the base plank. The one difference is that the base-to-2 1/4' high cut should be made as a lap joint (i.e. Make a mirror image of the above grooves in this piece, so that the horizontal planks will slot in. Next, take the second long vertical and nominate it as the middle-left vertical. Cut out grooves that are 3/8' deep and 1 1/2' in (matching the cut on the horizontal pieces) at the following positions from the bottom: Д«ottom to 2 1/4' high 17 1/2' to 19 3/4' 33 1/4' to top Prepare front frame pieces (left side) Now take one of the two longer vertical planks and nominate it as the right vertical. The one difference is that the base to 2 1/4' high cut should be made as a lap joint (i.e.

Next, take the second small vertical and nominate it as the middle-right vertical. Cut out grooves that are 3/8' deep and 1 1/2' in (matching the cut on the horizontal pieces) at the following positions from the bottom: Д«ottom to 2 1/4' high 10 3/4' to 13' 20 1/2' to 22 3/4' 29 3/4' to top Firstly, take one of the two shorter vertical pieces and nominate it as the left vertical. Now that all of the horizontal pieces are prepared, we need to prepare the vertical planks.

Note that when deciding which end is the right and left of this plank, lie the plank flat on the ground with the cut out lap joint part facing upwards (see diagram).

Next, cut a slot out of the base plank 13' from the right and 29 1/2' from the left (hence, 4 1/2' wide). Prepare front frame pieces (left side) Firstly, cut lap joints that are 1 1/2' in from each end into the two top pieces (long and short), the middle drawer pieces (two long, one short) and the base plank. Construction Tools required: router, drill, sander Wood required: pine and plywood DescriptionДЎ.

200 proyectos de carpinteria pdf